LK201 C200H PDF

Product category: PLCs – Omron – C – Omron CH-LK (CHLK) This unit is fully tested prior to. Q: Can CH-LKV1 Host Link Unit be used with CS1-series Programmable Controllers?. CH Units that use the CPU bus, SYSMAC LINK Unit, CHW-SLK23/24 ( wired) CHW-SLK13/14 (optical). Controller Link Unit, CHW-CLK21 (wired ).

Author: Kegar Yojar
Country: Saint Kitts and Nevis
Language: English (Spanish)
Genre: Spiritual
Published (Last): 8 April 2005
Pages: 398
PDF File Size: 5.90 Mb
ePub File Size: 7.37 Mb
ISBN: 979-7-71127-825-8
Downloads: 5671
Price: Free* [*Free Regsitration Required]
Uploader: Samurg

Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community. Maybe the backplane is bad. If it is not blinking then you have a bad connection.

Omron C200H-LK201 (C200HLK201)

It’s on page 9 in the manual. One says not to use those slots, the other says it’s OK but you will lose some functionality on the peripheral port. Maybe the PLC power supply is bad. With the information you have provided, there is no way for lo201 to tell.

  COMPUTERNETZWERKE DER TOP-DOWN-ANSATZ PDF

Last week, the cpu couldn’t power on, so I have replaced with a new CPU. Pin 3 on the back may be the problem depending on how your custom application was programmed. It is a pre-Alpha series. I also tried with this cable LK Coputer Sign in Already have an account?

The PLC configuration does not matter. Try to put il elsewhere. Remove all the modules from the rack and try the Host Link in another slot.

Share this post Link to post Share on other sites. PCMRthat Data will have to be reentered into the appropriate locations.

Sign up for a new account in our community. The restriction is strictly mechanical. Also the command level is set for a custom application for full read and write.

Posted 15 Nov Posted 13 Nov edited. But there’s still no RCV light Please help me!

Omron CCNEU Programming Cable, For Use With CH-LK PLC, 6 ft Buy from Cross

I will check the cable one more time! What is the part number of your back plane? The dip witches in the host link are correct but still not connect.

  ASTM D2596 PDF

I would still think you should see the RCV light. In any case, look here: Then the PLC cannot connect to Pc.

Omron C500CN221EU Programming Cable, For Use With C200H-LK201 PLC, 6 ft

Go To Topic Listing Omron. Help me with ch-lk Started by sokhanh13 Nov One of the other old school guys will have to answer this one. Posted 14 Nov edited. This is a node address. This is basically the same as the rack mounted unit you have. I did notice that both of his modules are in the restricted slots.